D-Link DWS-1008 User Manual page 77

DWS-1008 User's Manual
After you configure a port group, you can use the port group name with commands that
change Layer 2 configuration parameters to apply configuration changes to all ports in the
port group. For example, Spanning Tree Protocol (STP) and VLAN membership changes
affect the entire port group instead of individual ports. When you make Layer 2 configuration
changes, you can use a port group name in place of the port list. Ethernet port statistics
continue to apply to individual ports, not to port groups.
To configure a port group named server2 containing ports 3 and 5 and add the ports to the
default VLAN, type the following commands:
DWS-1008# set port-group name server2 3,5 mode on
success: change accepted.
DWS-1008# set vlan default port server2
success: change accepted.
To verify the configuration change, type the following command:
DWS-1008# show vlan config
VLAN Name
-----------------------------------------------------------------------------------------------------------
1 default
To indicate that the ports are configured as a port group, the show vlan config output lists
the port group name instead of the individual port numbers.
Removing a Port Group
To remove a port group, use the following command:
clear port-group name name
Displaying Port Group Information
To display port group information, use the following command:
show port-group [all | name group-name]
To display the configuration and status of port group server2, type the following command:
DWS-1008# show port-group name server2
Port group: server2 is up
Ports: 3, 5
Interoperating with Cisco Systems EtherChannel
D-Link Systems, Inc.
Admin VLAN
Status State
Up Up
Configuring and Managing Ports and VLANs
Tunl
Affin Port
5
server2
Port
Tag State
none Up
72