D-Link DWS-1008 User Manual page 73

DWS-1008 User's Manual
Resetting a Port
You can reset a port by toggling its link state and PoE state. MSS disables the port's link and
PoE (if applicable) for at least one second, then reenables them.
This feature is useful for forcing a DWL-8220 access point that is connected to two
DWS-1008 switches to reboot using the port connected to the other switch.
To reset a port, use the following command:
reset port port-list
Displaying Port Information
You can use CLI commands to display the following port information:
Port configuration and status
•
PoE state
•
Port statistics
•
You also can configure MSS to display and regularly update port statistics in a separate window.
Displaying Port Configuration and Status
To display port configuration and status information, use the following command:
show port status [port-list]
To display information for all ports, type the following command:
Note: PoE is supported only on 10/100 Ethernet ports. PoE is not supported on ports 7 and
8.
DWS-1008# show port status
Port Name Admin Oper
========================================================
1 1
2 2
3 3
4 4
5 5
6 6
7 7
8 8
In this example, two of the switch's ports, 1 and 6, have an operational status of up, indicating
the links on the ports are available.
D-Link Systems, Inc.
Config Actual
up up auto
up down auto
up down auto
up down auto
up down auto
up up auto
up down auto
up down auto
Configuring and Managing Ports and VLANs
Type
100/full network
network
network
network
network
100/full network
network
network
Media
10/100BaseTx
10/100BaseTx
10/100BaseTx
10/100BaseTx
10/100BaseTx
10/100BaseTx
10/100BaseTx
10/100BaseTx
68