D-Link DWS-1008 User Manual page 406

DWS-1008 User's Manual
Service-
Type
Filter-Id
Reply-
Message
State
D-Link Systems, Inc.
5 No Yes
11 Yes No
18 Yes No
24 Yes Yes
Appendix B - Supported RADIUS Attribites
Yes Access type, which can be one of the
following:
• 2 - Framed; for network user access
• 6 - Administrative; for administrative
access to the switch, with
authorization to access the enabled
(configuration) mode. The user must
enter the enable command and the
correct enable password to access
the enabled mode.
• 7 - NAS-Prompt; for administrative
access to the nonenabled mode only.
In this mode, the user can still enter
the enable command and the correct
enable password to access the
enabled mode.
For administrative sessions, the switch
always sends 6 (Administrative).
The RADIUS server can reply with one
of the values listed above.
If the service-type is not set on the
RADIUS server, administrative users
receive NAS-Prompt access, and
network users receive Framed access.
Name of an access control list (ACL) to
filter outbound or inbound traffic. Use the
form ACL name.in and ACL name.out.
No String. Text that can be displayed to the
user. Multiple Reply-Messages can be
included. If any are displayed, they must
appear in the order in which they appear
in the packet.
No Can be sent by a RADIUS server in
an Access-Challenge message to the
switch. If the switch receives an Access-
Challenge with this attribute, it returns
the same State value in an Access-
Request response to the RADIUS
server, when a response is required.
(For details, see RFC 2865.)
401