D-Link DWS-1008 User Manual page 123

DWS-1008 User's Manual
Creating a USM User for SNMPv3
To create a USM user for SNMPv3, use the following command:
set snmp usm usm-username
snmp-engine-id {ip ip-addr | local | hex hex-string}
access {read-only | read-notify | notify-only | read-write |
notify-read-write}
auth-type {none | md5 | sha} {auth-pass-phrase string | auth-key
hex-string}
encrypt-type {none | des | 3des | aes} {encrypt-pass-phrase string |
encrypt-key hex-string}
To clear a USM user, use the following command:
clear snmp usm usm-username
The usm-username can be up to 32 alphanumeric characters long, with no spaces.
You can configure up to 10 SNMPv3 users.
The snmp-engine-id option specifies a unique identifier for an instance of an SNMP engine.
To send informs, you must specify the engine ID of the inform receiver. To send traps and to
allow get and set operations and so on, specify local as the engine ID.
• hex hex-string - ID is a hexadecimal string.
• ip ip-addr - ID is based on the IP address of the station running the management
application. Enter the IP address of the station. MSS calculates the engine ID based
on the address.
• local - Uses the value computed from the switch's system IP address.
The access option specifies the access level of the user. The options are the same as the
access options for community strings.
D-Link Systems, Inc.
Configuring SNMP
118