D-Link DWS-1008 User Manual page 387

DWS-1008 User's Manual
Specifying a severity level sends log messages for events or conditions at that level or higher
to the logging destination. The table below lists the severity levels and their descriptions.
Event Severity Levels
Severity
emergency
alert
critical
error
warning
notice
info
debug
Using Log Commands
To enable, disable, or modify system logging to the switch's log buffer, console, current Telnet
session, or trace buffer, use the following command:
set log {buffer | console | current | sessions | trace} [severity severity-level]
[enable | disable]
To enable, disable, or modify system logging to a syslog server, use the following
command:
set log server ip-addr [severity severity-level [local-facility facility-name]]
[enable | disable]
To view log entries in the system or trace buffer, use the following command:
show log buffer | trace
To clear log messages from the system or trace buffer, use the following command:
clear log buffer | trace
D-Link Systems, Inc.
Description
The switch is unusable.
Action must be taken immediately.
You must resolve the critical conditions. If the
conditions are not resolved, the can reboot or
shut down.
The switch is missing data or is unable to form a
connection.
A possible problem exists.
Events that potentially can cause system
problems have occurred. These are logged for
diagnostic purposes. No action is required.
Informational messages only. No problem exists.
Output from debugging.
Note. The debug level produces a lot of
messages, many of which can appear to be
somewhat cryptic. Debug messages are used
primarily by D-Link for troubleshooting and are
not intended for administrator use.
Appendix A - Troubleshooting
382