D-Link DWS-1008 User Manual page 29

DWS-1008 User's Manual
Verifying IP Connectivity
To verify that the switch can send and receive IP traffic, use the following command:
ping host
The ping command sends an Internet Control Message Protocol (ICMP) echo packet to the
specified device and listens for a reply packet. For host, specify the IP address of a host
device on the network.
Note: If you configure the Domain Name Service (DNS) or set a local alias for the host
device, you can specify the DNS hostname or the alias instead of the IP address of the
device.
The following command verifies IP connectivity to IP address 10.10.20.19:
DWS-1008# ping 10.10.20.19
PING 10.10.20.19 (10.10.20.19) from 10.10.20.2 : 56(84) bytes of data.
64 bytes from 10.10.20.19: icmp_seq=1 ttl=255 time=0.769 ms
64 bytes from 10.10.20.19: icmp_seq=2 ttl=255 time=0.628 ms
64 bytes from 10.10.20.19: icmp_seq=3 ttl=255 time=0.676 ms
64 bytes from 10.10.20.19: icmp_seq=4 ttl=255 time=0.619 ms
64 bytes from 10.10.20.19: icmp_seq=5 ttl=255 time=0.608 ms
--- 20.20.20.1 ping statistics ---
5 packets transmitted, 5 packets received, 0 errors, 0% packet loss
D-Link Systems, Inc.
Configuration (continued)
Configuration
24