D-Link DWS-1008 User Manual page 117

DWS-1008 User's Manual
* = From DHCP
VLAN Name
-------------------------------------------------------------------------------------------------------------------
1 default
2 roaming
2. Configure the IP interface on the roaming VLAN to be the system IP address and verify the
configuration change. Type the following commands:
DWS-1008# set system ip-address 10.20.10.10
success: change accepted.
DWS-1008# show system
=============================================================
Product Name:
System Name:
System Countrycode: US
System Location:
System Contact:
System IP:
System MAC:
=============================================================
Boot Time:
Uptime:
=============================================================
Fan status: fan1 OK
Temperature: temp1 ok
PSU Status: Lower Power Supply DC ok
Memory:
Total Power Over Ethernet : 105.6
=============================================================
3. Configure a default route through a gateway router attached to the Switch and verify the
configuration change. Type the following commands:
DWS-1008# set ip route default 10.20.10.1 1
success: change accepted.
D-Link Systems, Inc.
Address
10.10.10.10
10.20.10.10
DWS-1008
DWS-1008
10.02.10.10
00:0B:0E:00:04:0C
2000-03-18 22:59:19
0 days 01:12:02
fan2 OK
temp2 ok
156.08/496.04 (31%)
Configuring and Managing IP Interfaces and Services
Mask
255.255.255.0
255.255.255.0
fan3 OK
temp3 ok
AC ok
Enabled State RIB
YES Up
YES Up
Upper Power Supply missing
ipv4
ipv4
112