D-Link DWS-1008 User Manual page 197

DWS-1008 User's Manual
2. Create a service profile named wpa-wep for the SSID. Type the following command:
DWS-1008# set service-profile wpa-wep
success: change accepted.
3. Set the SSID in the service profile to thiscorp. Type the following command:
DWS-1008# set service-profile wpa-wep ssid-name thiscorp
success: change accepted.
4. Enable WPA in service profile wpa-wep. Type the following command:
DWS-1008# set service-profile wpa-wep wpa-ie enable
success: change accepted.
5. Enable the WEP40 cipher suite in service profile wpa-wep. Type the following command:
DWS-1008# set service-profile wpa-wep cipher-wep40 enable
success: change accepted.
TKIP is already enabled by default when WPA is enabled.
6. Display the service profile wpa-wep to verify the changes. Type the following command:
DWS-1008# show service-profile wpa-wep
ssid-name:
beacon:
WEP Key 1 value:
WEP Key 3 value:
WEP Unicast Index:
Long Preamble:
WPA enabled:
ciphers: cipher-tkip, cipher-wep40
authentication: 802.1X
TKIP countermeasures time: 60000ms
7. Map service profile wpa-wep to radio profile rp2. Type the following commands:
DWS-1008# set radio-profile rp2 service-profile wpa-wep
success: change accepted.
D-Link Systems, Inc. D-Link Systems, Inc.
mycorp ssid-type:
yes auth-fallthru: none
<none> WEP Key 2 value:
<none> WEP Key 4 value:
1 WEP Multicast Index:
YES Shared Key Auth:
crypto
<none>
<none>
1
NO
Configuring User Encryption
192 192