D-Link DWS-1008 User Manual page 154

DWS-1008 User's Manual
To display the AP settings in the template, type the following command:
DWS-1008# show dap config auto
Dap auto: mode: disabled bias: high
boot-download-enable: YES
load balancing group: none
Radio 1: type: 802.11g, mode: enabled, channel: dynamic
tx pwr: 15, profile: default
auto-tune max-power: default, min-client-rate: 5.5, max-retransmissions: 10
Radio 2: type: 802.11a, mode: enabled, channel: dynamic
tx pwr: 11, profile: default
auto-tune max-power: default, min-client-rate: 24, max-retransmissions: 10
This example shows the defaults for the AP parameters you can configure in the template. The
table below lists the configurable template parameters and their defaults. The only parameter
that requires configuration is the template mode. The template is disabled by default. To use
the template to configure Distributed APs, you must enable the template.
Parameter
AP Parameters
mode
bias
upgrade-firmware (boot-
download-enable)
group (load balancing
group)
blink
(Not shown in show dap
config output)
Radio Parameters
radiotype (type)
(Applies only to single-
radio AP models)
mode
tx-pwr
radio-profile (profile)
max-power
min-client-rate
max-retransmissions
D-Link Systems, Inc.
fingerprint
Configurable Template Parameters for
Distributed APs
Default Value
disabled
high
enable (YES)
none
disable
11g
(or 11b for country codes
where 802.11g is not
allowed)
enabled
Highest setting allowed
for the country of
operation
default
default
5.5 for 802.11b/g
24 for 802.11a
10
Configuring DWL-8220AP Access Points
149