D-Link DWS-1008 User Manual page 207

DWS-1008 User's Manual
Changing RF AutoTuning Settings
Disabling or Reenabling Channel Tuning
RF AutoTuning for channels is enabled by default. To disable or reenable the feature for all
radios in a radio profile, use the following command:
set radio-profile name auto-tune channel-config {enable | disable}
To disable channel tuning for radios in the rp2 radio profile, type the following command:
DWS-1008# set radio-profile rp2 auto-tune channel-config disable
success: change accepted.
Changing the Channel Tuning Interval
The default channel tuning interval is 3600 seconds. You can change the interval to a value
from 0 to 65535 seconds. If you set the interval to 0, RF AutoTuning does not reevaluate
the channel at regular intervals. However, RF AutoTuning can still change the channel in
response to RF anomalies. D-Link recommends that you use an interval of at least 300
seconds (5 minutes).
To change the channel tuning interval, use the following command:
set radio-profile name auto-tune channel-interval seconds
To set the channel tuning interval for radios in radio profile rp2 to 2700 seconds (45 minutes),
type the following command:
DWS-1008# set radio-profile rp2 auto-tune channel-interval 2700
success: change accepted.
Changing the Channel Holddown Interval
The default channel holddown interval is 900 seconds. You can change the interval to a
value from 0 to 65535 seconds. To change the channel holddown interval, use the following
command:
set radio-profile name auto-tune channel-holddown holddown
To change the channel holddown for radios in radio profile rp2 to 600 seconds, type the
following command:
DWS-1008# set radio-profile rp2 auto-tune channel-holddown 600
success: change accepted.
D-Link Systems, Inc.
Configuring RF Auto-Tuning
202