D-Link DWS-1008 User Manual page 156

DWS-1008 User's Manual
Displaying Status Information for APs Configured by the Template
To display status information for APs configured by the template, type the following
command:
DWS-1008# show dap status auto
Dap: 100 (auto), IP-addr: 10.8.255.6 (vlan 'default'), AP model: DWL-8220AP,
manufacturer: D-Link, name: AP100
====================================================
State: operational (not encrypted)
CPU info: IBM:PPC speed=266666664 Hz version=405GPr
Uptime: 18 hours, 36 minutes, 27 seconds
Radio 1 type: 802.11g, state: configure succeed [Enabled] (802.11b protect)
operational channel: 1 operational power: 14
base mac: 00:0b:0e:00:d2:c0
bssid1: 00:0b:0e:00:d2:c0, ssid: public
bssid2: 00:0b:0e:00:d2:c2, ssid: employee-net
bssid3: 00:0b:0e:00:d2:c4, ssid: mycorp-tkip
Radio 2 type: 802.11a, state: configure succeed [Enabled]
operational channel: 64 operational power: 14
base mac: 00:0b:0e:00:d2:c1
bssid1: 00:0b:0e:00:d2:c1, ssid: public
bssid2: 00:0b:0e:00:d2:c3, ssid: employee-net
bssid3: 00:0b:0e:00:d2:c5, ssid: mycorp-tkip
The output displays auto next to the Distributed AP number to indicate that the AP was
configured using a template.
Converting a DWL-8220AP Configured by the Template into a Permanent
AP
You can convert a temporary AP configuration created by the template into a persistent AP
configuration on the switch. To do so, use the following command:
set dap auto persistent {dap-num | all}
This command creates a persistent Distributed AP configuration based on the settings in the
template. The Distributed AP name and number assigned by the template are used for the
persistent entry. For example, if the template assigned the number 100 and the name AP100
to the AP, the persistent configuration for the AP has the same number and name. In this
case, use 100 as the dap-num with show dap, set dap, or clear dap commands.
The AP continues to operate without interruption after you enter the set dap auto persistent
command. The next time the AP is restarted, the template is not used to configure the AP.
Instead, the persistent configuration is used. (Use the save config command to make the AP
configuration persistent across switch restarts.)
D-Link Systems, Inc.
id= ram=33554432
s/n=0333703027 hw_rev=A3
Configuring DWL-8220AP Access Points
151