D-Link DWS-1008 User Manual page 31

DWS-1008 User's Manual
The following example sets the country code to US (United States) and verifies
the setting:
DWS-1008# set system countrycode US
success: change accepted.
DWS-1008# show system
=============================================================
Product Name: DWS-1008
System Name: DWS-1008
System Countrycode: US
System Location:
System Contact:
System Description: DWS-1008
System IP: 0.0.0.0
System MAC: 00:0B:0E:02:76:F6
=============================================================
Boot Time: 2003-05-07 08:28:39
Uptime: 0 days 04:00:07
=============================================================
Fan status: fan1 OK fan2 OK fan3 OK
Temperature: temp1 ok temp2 ok temp3 ok
PSU Status: Lower Power Supply DC ok AC ok Upper Power Supply missing
Memory: 115.09/496.04 (23%)
Total Power Over Ethernet : 32.000
=============================================================
Specifying a System IP Address
You can designate one of the IP addresses configured on a DWS-1008 switch's VLAN to be
the system IP address of the switch. The system IP address provides a common IP interface
and source IP address for some management and MobileLAN operations. The system IP
address is required by some features, including roaming. The system IP address is also
used by default for other features, including RADIUS and the system log.
To assign one of the configured IP addresses to be the system IP address, use the following
command:
set system ip-address ip-addr
Enter an IP address in dotted decimal notation (xxx.xxx.xxx.xxx). This command sets the IP
address you specify to be the system IP address.
D-Link Systems, Inc.
Configuration (continued)
Configuration
26