D-Link DWS-1008 User Manual page 40

DWS-1008 User's Manual
Note: You can configure an AP configuration template for automatically configuring Distributed
APs when they boot using the DWS-1008 switch.
The following example configures connections for two Distributed APs that are indirectly
connected to the switch. Note that when you create a connection, you assign it a number
that can be used later for displaying and configuration, much like the physical ports for
directly connected APs:
DWS-1008# set dap 1 serial-id 0322199999 model dwl-8220ap
success: change accepted.
DWS-1008# set dap 2 serial-id 0322199998 model dwl-8220ap
success: change accepted.
To verify the configuration change, use the following command:
show dap config [dap-num [radio {1 | 2}]]
Here is an example:
DWS-1008# show dap config
Dap 1: serial-id: 0322199999, AP model: dwl-8220ap, bias: high, name: DAP01
fingerprint:
boot-download-enable: YES
load balancing group: none
Radio 1: type: 802.11g, mode: disabled, channel: dynamic
tx pwr: 14, profile: default
auto-tune max-power: default, min-client-rate: 5.5, max-retransmissions: 10
Radio 2: type: 802.11a, mode: disabled, channel: dynamic
tx pwr: 11, profile: default
auto-tune max-power: default, min-client-rate: 24, max-retransmissions: 10
Dap 2: serial-id: 0322199998, AP model: dwl-8220ap, bias: high, name: DAP02
fingerprint:
boot-download-enable: YES
load balancing group: none
Radio 1: type: 802.11g, mode: disabled, channel: dynamic
tx pwr: 14, profile: default
auto-tune max-power: default, min-client-rate: 5.5, max-retransmissions: 10
Radio 2: type: 802.11a, mode: disabled, channel: dynamic
tx pwr: 11, profile: default
auto-tune max-power: default, min-client-rate: 24, max-retransmissions: 10
D-Link Systems, Inc.
Configuration (continued)
Configuration
35