D-Link DWS-1008 User Manual page 69

DWS-1008 User's Manual
To set ports 4 through 6 for the DWL-8220AP and enable PoE on the ports, type the
following command:
DWS-1008# set port type ap 4-6 model DWL-8220AP poe enable
This may affect the power applied on the configured ports. Would you like
to continue? (y/n) [n]y
success: change accepted.
DWS-1008# set port type ap 2 model DWL-8220AP poe enable radiotype 11b
This may affect the power applied on the configured ports. Would you like
to continue? (y/n) [n]y
success: change accepted.
Configuring for a Distributed AP
To configure a connection for a Distributed AP (referred to as a DAP in the CLI),
use the following command:
set dap dap-num serial-id serial-ID
model {DWL-8220AP} [radiotype {11a | 11b| 11g}]
The dap-num parameter identifies the Distributed AP connection for the DWL-8220AP. The
range of valid connection ID numbers is 1 to 30.
For the serial-id parameter, specify the serial ID of the AP. The serial ID is listed on the case.
To display the serial ID using the CLI, use the show version details command.
The model and radiotype parameters have the same options as they do with the set port
type ap command. Because the switch does not supply power to an indirectly connected AP,
the set dap command does not use the poe parameter.
To configure Distributed AP connection 1 for the DWL-8220AP with serial-ID
0322199999, type the following command:
DWS-1008# set dap 1 serial-id 0322199999 model DWL-8220AP
success: change accepted.
To configure Distributed AP connection 2 with serial-ID 0322188888 and radio type 802.11a,
type the following command:
DWS-1008# set dap 2 serial-id 0322188888 model dwl-8220ap radiotype 11a
success: change accepted.
D-Link Systems, Inc.
Configuring and Managing Ports and VLANs
64