D-Link DWS-1008 User Manual page 229

DWS-1008 User's Manual
Bridge ID Priority
Bridge Max Age 20 sec Hello Time 2 sec Forward Delay 15 sec
Port
--------------------------------------------------------------------
2
3
4. Reconnect or reenable ports 2 and 3 and verify the change. Type the following
commands:
DWS-1008# set port enable 2-3
success: set "enable" on port 2-3
DWS-1008# show port status
Port Name Admin Oper
=============================================================
1
2
3
4
5
6
7
8
5. Wait for STP to complete the listening and learning stages and converge, then verify that
STP is operating properly and blocking one of the ports in the backbone VLAN. Type the
following command:
DWS-1008# show spantree vlan 10
VLAN 10
Spanning tree mode
Spanning tree type
Spanning tree enabled
Designated Root
Designated Root Priority
Designated Root Path Cost
We are the root
Root Max Age 20 sec Hello Time 2 sec Forward Delay 15 sec
Bridge ID MAC ADDR
Bridge ID Priority
Bridge Max Age 20 sec Hello Time 2 sec Forward Delay 15 sec
Port
---------------------------------------------------------------------------
2
3
6. Save the configuration. Type the following command:
D-Link Systems, Inc. D-Link Systems, Inc.
32768
Vlan Port-State
10 Disabled
10 Disabled
Config
up up auto
up up auto
up up auto
up down auto
up down auto
up down auto
up down auto
up down auto
PVST+
IEEE
00-0b-0e-00-04-0c
32768
0
00-0b-0e-00-04-0c
32768
Vlan Port-State Cost Prio Portfast
10 Forwarding
10 Blocking
Cost Prio Portfast
4 128 Disabled
4 128 Disabled
Actual Type
100/full network
100/full network
100/full network
network
network
network
network
network
4 128 Disabled
4 128 Disabled
Configuring and Managing STP
Media
10/100BaseTx
10/100BaseTx
10/100BaseTx
10/100BaseTx
10/100BaseTx
10/100BaseTx
224 224