Alcatel-Lucent 7750 SR OS Interface Configuration Manual page 590

Show Commands
Sample Output
A:ALA-48>config# show lag
===============================================================================
Lag Data
===============================================================================
Lag-id
-------------------------------------------------------------------------------
1
2
3
4
10
-------------------------------------------------------------------------------
Total Lag-ids: 5
===============================================================================
A:ALA-48>config# show lag
Detailed LAG Output — The following table describes detailed LAG output fields. The output is
dependent on whether or not the LAG was configurd as a multi-chassis LAG.
Detailed LAG Output Fields
Page 590
Adm
up
up
up
up
up
Label
LAG ID
Adm
Port Threshold
Thres. Last
Cleared
Dynamic Cost
Configured
Address
Hardware Address
Hold-Time Down
LACP
LACP Transmit
Intvl
Selection Crite-
ria
Number of sub-
groups
Opr Port-Threshold
down 0
up 0
down 0
down 0
down 0
Single Chassis: 2
The LAG or multi-link trunk (MLT) that the port is assigned to.
Up — The LAG is administratively up.
Down — The LAG is administratively down.
If the number of available links is equal or below this number, the
threshold action is executed.
The last time that keepalive stats were cleared.
The OSPF costing of a link aggregation group based on the available
aggregated, operational bandwidth.
The base chassis Ethernet MAC address.
The hardware address.
The timer, in tenths of seconds, which controls the delay between
detecting that a LAG is down and reporting it to the higher levels.
Enabled — LACP is enabled.
Down — LACP is disabled.
LACP timeout signalled to peer.
Configured subgroup selection criteria.
Total subgroups in LAG.
7750 SR OS Interface Configuration Guide
Up-Link-Count MC Act/Stdby
0 N/A
1 active
0 standby
0 standby
0 N/A
MC Act: 1 MC Stdby: 2
Description