Alcatel-Lucent 7750 SR OS Interface Configuration Manual page 376

Configuration Commands
report-alarm
Syntax [no] report-alarm [loc] [lais] [lrdi] [ss1f] [lb2er-sd] [lb2er-sf] [slof] [slos] [lrei]
Context config>port>sonet-sdh
Description This command enables logging of SONET (SDH) line and section alarms for a SONET-SDH port.
Only line and section alarms can be configured in the SONET/SDH context, for path alarms see the
sonet-sdh>path context.
The no form of this command disables logging of the specified alarms
Parameters
loc — Reports a loss of clock which causes the operational state of the port to be shut down.
lais — Reports line alarm indication signal errors. When configured, lais alarms are raised and
lrdi — Reports line remote defect indication errors. LRDI's are caused by remote LOF, LOC, LOS.
ss1f — Reports section synchronization failure which is detected when the S1 byte is not consistent
lb2er-sd — Reports line signal degradation BER (bit interleaved parity) errors. Use the threshold
lb2er-sf — Reports line signal failure BER errors. Use the threshold command to set the error rate(s)
slof — Reports section loss of frame errors. When configured, slof alarms are raised and cleared.
slos — Reports a section loss of signal error on the transmit side. When configured, slos alarms are
lrei — Reports a line error condition raised by the remote as a result of b1 errors received from this
Page 376
Default
loc alarms are issued.
cleared.
Default lais alarms are not issued.
When configured, lrdi alarms are raised and cleared.
Default
lrdi alarms are issued.
for 8 consecutive frames. When configured, ss1f alarms are raised and cleared.
Default
ss1f alarms are not issued.
command to set the error rate(s) that when crossed determine signal degradation and signal
failure. When configured, lb2er-sd alarms are raised and cleared.
Default lb2er-sd alarms are not issued.
that when crossed determine signal degradation and signal failure.When configured, lb2er-sf
alarms are raised and cleared.
Default lb2er-sf alarms are issued.
Default
slof alarms are issued.
raised and cleared.
Default slos alarms are issued.
node. When configured, lrei traps are raised but not cleared
Default lrei traps are not issued.
7750 SR OS Interface Configuration Guide