Alcatel-Lucent 7750 SR OS Interface Configuration Manual page 414

Configuration Commands
los — Reports loss of signal errors. When configured, los traps are not raised and cleared.
oof — Reports out-of-frame errors. When configured, oof alarms are not raised and cleared.
rai — Reports resource availability indicator events. When configured, rai events are not raised and
looped — Reports looped packets errors.
looped alarms are not issuedlof — Reports loss of frame errors. When configured, lof traps are not
signal-mode
Syntax signal-mode {cas}
no signal-mode
Context config>port>tdm>ds1
config>port>tdm>e1
Description
This command activates the signal mode on the channel. When enabled, it uses routing information
to direct the payload of voice or data to its destination.
The no form of the command reverts to the default value.
Default no signal-mode
Parameters
cas — Specifies channel associated signaling.
speed
Syntax speed {56 | 64}
Context config>port>tdm>ds1>channel-group
config>port>tdm>e1>channel-group
Description This command sets the speed of the DS-0 channels used in the associated channel-group.
If the higher order channel is a channelized DS-3 then the channels must be DS-1s.
If the higher order channel is a channelized E-3 then the channels must be E-1s.
Default
64
Page 414
Default los traps are issued.
Default
oof alarms are not issued.
cleared.
Default
rai alarms are not issued
raised and cleared.
Default
lof traps are issued
Default
7750 SR OS Interface Configuration Guide