Alcatel-Lucent 7750 SR OS Interface Configuration Manual page 441

low-priority-defect
Syntax low-priority-defect {allDef | macRemErrXcon | remErrXcon | errXcon | xcon | noXcon}
Context config>eth-tunnel>path>eth-cfm>mep
Description
This command specifies the lowest priority defect that is allowed to generate a fault alarm.
Default remErrXcon
mac-address
Syntax mac-address mac-address
no mac-address
Context config>eth-tunnel>path>eth-cfm>mep
Description
This command specifies the MAC address of the MEP.
The no form of this command reverts the MAC address of the MEP back to that of the port (if the
MEP is on a SAP) or the bridge (if the MEP is on a spoke SDP).
Parameters mac-address — Specifies the MAC address of the MEP.
control-mep
Syntax [no] control-mep
Context config>eth-tunnel>path>eth-cfm>mep
Description
This command enables the usage of the CC state by the Ethernet tunnel manager for consideration in
the protection algorithm. The use of control-mep command is recommended if fast failure detection is
required, especially when Link Layer OAM does not provide the required detection time.
The no form of this command disables the use of the CC state by the Ethernet tunnel manager\.
Default no control-mep
7750 SR OS Interface Configuration Guide
Values
allDef
macRemErrXconOnly DefMACstatus, DefRemoteCCM, DefErrorCCM, and
remErrXcon Only DefRemoteCCM, DefErrorCCM, and DefXconCCM
errXcon
xcon
noXcon
Values
6-byte unicast mac-address (xx:xx:xx:xx:xx:xx or xx-xx-xx-xx-xx-xx) of the MEP.
Using the all zeros address is equivalent to the no form of this command.
DefRDICCM, DefMACstatus, DefRemoteCCM, DefErrorCCM,
and DefXconCCM
DefXconCCM
Only DefErrorCCM and DefXconCCM
Only DefXconCCM; or
No defects DefXcon or lower are to be reported
Interface Configuration
Page 441