Alcatel-Lucent 7750 SR OS Interface Configuration Manual page 533

A;ALA-1#
Port Frame Relay Output — The following table describes port Frame Relay output fields.
Port Frame Relay Output Fields
Sample Output
A:ALA-49>config>port# show port 8/1/2 frame-relay
===============================================================================
Frame Relay Info for 8/1/2
===============================================================================
Mode
FR Interface Status
N391 DTE
N392 DTE
N393 DTE
T391 DTE
Tx Status Enquiry
Rx Status Messages
Status Message Timeouts : 0
Discarded Messages
===============================================================================
A:ALA-49>config>port#
OTU Output — The following table describes the OTU output fields.
Port Frame Relay Output Fields
7750 SR OS Interface Configuration Guide
Label
Mode
LMI Type
FR Interface
Status
Label
OTU Status
Displays the mode of the interface. It can be set as Data terminal equip-
ment (dte) or Data circuit-terminating equipment (DCE).
Displays the LMI type.
Displays the status of the Frame Relay interface as determined by the
performance of the dlcmi. If no DLCMI is running, the Frame Relay
interface will stay in the running state indefinitely.
: dte LMI Type
: fault
: 6 N392 DCE
: 3 N393 DCE
: 4 T392 DCE
: 10
: 0 Rx Status Enquiry
: 0 Tx Status Messages
Status Enquiry Timeouts : 0
: 0 Inv. RxSeqNum Messages
Status of the OTU (Optical Transport Unit): enabled or disabled.
When OTU is enabled, and additional layer of framing encapsulates an
MDA's natively programmed mode of operation, 10-Gigabit Ethernet
LAN or WAN, adding SONET-Like Framing with FEC (Forward Error
Correction). When OTU is disabled, the MDA operates in a 10-Giga-
bit Ethernet LAN or WAN as per Ethernet provisioning.
Interface Configuration
Description
: itu
: 3
: 4
: 15
: 0
: 0
: 0
Description
Page 533