Alcatel-Lucent 7750 SR OS Interface Configuration Manual page 369

Parameters
yellow-diff-delay — Specify the maximum yellow differential delay threshold value.
ima
Syntax ima
Context config>port>multilink-bundle
Description This command enables the context to configure parameters for an Inverse Multiplexing over ATM
(IMA) group. An IMA group is a collection of physical links bundled together and assigned to an
ATM interface. IMA enables a high-speed channel that is composed of ATM cells to be transported as
a number of lower-speed circuits. Then they are reassembled as the original high-speed ATM channel.
This command is only valid for IMA bundles.
link-delay
Syntax link-delay {activate | deactivate} milli-seconds
no link-delay {activate | deactivate}
Context config>port>multilink-bundle>ima
Description
This command specifies the time to delay between detection of a link activation/deactivation
condition and acting upon it (going in/out of the RX failure state on a link).
Parameters
activate milli-seconds — Specifies the time, in milli-seconds, used to clear an existing LIF or LODS
deactivate milli-seconds — Specifies the time, in milli-seconds, used to raise an LIF or LODS alarm.
7750 SR OS Interface Configuration Guide
Values
1— 25 milliseconds
alarm. The time specified determines how long is needed for member links to stabilize before
being activated.
Values
1 — 30000 milli-seconds
Default
10000
The time specified determines how long before a member link is declared in error and is
deactivated.
Values
1 — 30000 milli-seconds
Default
2000
Interface Configuration
Page 369