Alcatel-Lucent 7750 SR OS Interface Configuration Manual page 452

Configuration Commands
source-bmac-lsb MAC-Lsb — Configures the last 16 bit of the MAC address to be used for all traffic
source-address
Syntax source-address ip-address
no source-address
Context config>redundancy>multi-chassis>peer
Description
This command specifies the source address used to communicate with the multi-chassis peer.
Parameters
ip-address — Specifies the source address used to communicate with the multi-chassis peer.
sync
Syntax [no] sync
Context config>redundancy>multi-chassis>peer
Description
This command enables the context to configure synchronization parameters.
igmp
Syntax [no] igmp
Context config>redundancy>multi-chassis>peer>sync
Description This command specifies whether IGMP protocol information should be synchronized with the multi-
chassis peer.
Default
no igmp
Page 452
ingressing the MC-LAG link(s) or if use-lacp-key option is used, it will onlycopy the value of
lacp-key (redundancy multi-chassis mc-lag lag lacp-key admin-key). The command will fail if
the value is the same with any of the following configured attributes:
- source-bmac-lsb assigned to other MC-LAG ports
- lsb 16 bits value for the source-bmac configured at chassis or BVPLS level
The first 32 bits will be copied from the source BMAC of the BVPLS associated with the IVPLS
for a specific IVPLS SAP mapped to the MC-LAG. The BVPLS source BMAC can be
provisioned for each BVPLS or can be inherited from the chassis PBB configuration.
Values
1 — 65535 or xx-xx or xx:xx
7750 SR OS Interface Configuration Guide