Alcatel-Lucent 7750 SR OS Interface Configuration Manual page 436

Configuration Commands
protection-type
Syntax protection-type {g8031-1to1 | loadsharing}
Context config>eth-tunnel
Description This command configures the model used for determining which members are actively receiving and
transmitting data.
The no form of the command reverts the default.
Default
no path-threshold
Parameters
g8031-1to1 — As per G.8031 spec, only two members are allowed, and only one of them can be
loadsharing — Multiple members can be active at one point in time.
revert-time
Syntax revert-time time
no revert-time
Context config>eth-tunnel
Description
This command configure how long to wait before switching back to the primary path after it has been
restored to Ethernet tunnel.
The no form of this command sets the revert-time to the default value.
Default
no revert-time – indicates non-revertive behavior.
Parameters time — Specifies the re-activation delay in seconds for the primary path.
path
Syntax [no] path path-index
Context config>eth-tunnel
Description
This command configures one of the two paths supported under the Ethernet tunnel. Although the
values indicate 1 — 8, only two paths, 1 and 2, are currently supported.
The no form of this command removes the path from under the Ethernet tunnel. If this is the last path,
the associated SAP need to be un-configured before the path can be deleted.
Default no path
Parameters path-index — Specifies the identifier for the path.
Page 436
active at one point in time.
Values
1 — 720 seconds
Values 1 — 8
7750 SR OS Interface Configuration Guide