Alcatel-Lucent 7750 SR OS Interface Configuration Manual page 274

Configuration Commands
config>card>mda>network
config>port>access
Description
This command enables the context to configure ingress buffer pool parameters which define the
percentage of the pool buffers that are used for CBS calculations and specify the slope policy that is
configured in the config>qos>slope-policy context.
On the MDA level, access ingress pools are only allocated on channelized MDAs/CMAs.
pool
Syntax [no] pool [name]
Context config>card>mda>access>egress
config>card>mda>access>ingress
config>card>mda>network>egress
config>port>access>egress
config>port>access>ingress
config>port>network>egress
config>port>network>ingress
config>port>access>uplink>egress
Description
This command configures pool policies.
On the MDA level, access and network egress and access ingress pools are only allocated on
channelized MDAs. On the MDA level, access and network egress and access ingress pools are only
allocated on channelized MDAs. Network ingress pools are allocated on the MDA level for non-
channelized MDAs.
Default default
Parameters
name — Specifies the pool name, a string up to 32 characters long composed of printable, 7-bit
resv-cbs
Syntax resv-cbs percent-or-default
no resv-cbs
Context config>port>access>egress>pool
config>port>ethernet>network
config>card>mda>access>egress
config>card>mda>access>ingress
config>card>mda>network>egress
config>card>mda>network>ingress
config>port>access>egress>channel>pool
config>port>access>ingress>pool
config>port>network>egress>pool
Page 274
ASCII characters. If the string contains special characters (#, $, spaces, etc.), the entire string
must be enclosed within double quotes.
7750 SR OS Interface Configuration Guide