Alcatel-Lucent 7750 SR OS Interface Configuration Manual page 349

LLDP Port Commands
lldp
Syntax lldp
Context config>port>ethernet
Description
This command enables the context to configure Link Layer Discovery Protocol (LLDP) parameters
on the specified port.
dest-mac
Syntax dest-mac {bridge-mac}
Context config>port>ethernet>lldp
Description
This command configures destination MAC address parameters.
Parameters
bridge-mac — Specifies destination bridge MAC type to use by LLDP.
admin-status
Syntax admin-status {rx | tx | tx-rx | disabled}
Context config>port>ethernet>lldp>dstmac
Description
This command configures LLDP transmission/reception frame handling.
Parameters
rx — Specifies the LLDP agent will receive, but will not transmit LLDP frames on this port.
tx — Specifies that the LLDP agent will transmit LLDP frames on this port and will not store any
tx-rx — Specifies that the LLDP agent will transmit and receive LLDP frames on this port.
disabled — Specifies that the LLDP agent will not transmit or receive LLDP frames on this port. If
7750 SR OS Interface Configuration Guide
Values
nearest-bridge — Specifies to use the nearest bridge.
nearest-non-tpmr — Specifies to use the nearest non-Two-Port MAC Relay
(TPMR) .
nearest-customer — Specifies to use the nearest customer.
information about the remote systems connected.
there is remote systems information which is received on this port and stored in other tables,
before the port's admin status becomes disabled, then the information will naturally age out.
Interface Configuration
Page 349