Alcatel-Lucent 7750 SR OS Interface Configuration Manual page 467

ancillary-override
Syntax ancillary-override
Context config>card>mda>ingress>mcast-mgmt
Description
This command enables the context to configure MDA ingress multicast path-limit overrides.
path-limit
Syntax path-limit megabits-per-second
no path-limit
Context config>card>mda>ingress>mcast-mgmt>primary-override
config>card>mda>ingress>mcast-mgmt>secondary-override
config>card>mda>ingress>mcast-mgmt>ancillary-override
Description
The path-limit command is used to override the path limits contained in the bandwidth policy
associated with the MDA. The path limits are used to give the upper limit that multicast channels may
use on each path.
The path-limit commands are not supported on IOM-3.
The no form of the command removes a path limit override from an ingress multicast path and restore
the path limit defined in the bandwidth policy associated with the MDA.
Parameters
megabits-per-second — The megabits-per-second parameter is required when executing the path-
cpm
Syntax cpm
Context tools>dump>mcast-path-mgr
Description This command dumps multicast path manager CPM information.
Sample Output
*A:Dut-C# tools dump mcast-path-mgr cpm
McPathMgr[10][0]: 0x763a52c0 blkHoleEval 0
inUseBw
7750 SR OS Interface Configuration Guide
limit command and is expressed as an integer representing multiples of 1,000,000 bits per
second.
Values
Primary-override:
Secondary-override:
Ancillary-override:
Default
None
pPath swPlaneID
maxUsedBw numSGs
1 to 2000
1 to 2000
1 to 5000
pathType availBw
Interface Configuration
pathLimit
Page 467