Alcatel-Lucent 7750 SR OS Interface Configuration Manual page 291

tx
Syntax tx
tx
tx
tx
no tx
Context config>port>otu>pm-tti>tx
Description
This command enables the user to configure the transmit (tx) trail trace identifier (TTI) for path
monitoring (PM) in the ODU overhead. This identifier can be a string or a non-printable sequence of
bytes. The length of the string or sequence of bytes cannot exceed 64 bytes.
The no form of the command reverts to the default TTI.
Default Auto-generated in the format of nodename:iomnum/mdanum/portnum/dwdmchan
The auto-generated value has five sections:
Parameters
auto-generated — Specifies to use the system generated (default) TTI.
string identifier — Sets the PM TTI to the string provided by the user. If the string is less than 64
bytes byte1 [byte2...(up to 64 bytes)] — Sets the PM TTI to the sequence of bytes provided by the
tx
Syntax tx {auto-generated | string identifier | bytes byte1 [byte2...(up to 64 bytes)]}
no tx
Context config>port>otu>sm-tti>tx
Description
This command allows the user to configure the transmit (tx) trail trace identifier (TTI) for section
monitoring (SM) in the OTU overhead. This identifier can be a string or a non-printable sequence of
bytes. The length of the string or sequence of bytes cannot exceed 64 bytes.
The no form of the command reverts to the default TTI.
Default
Auto-generated in the format of nodename:iomnum/mdanum/portnum/dwdmchan
7750 SR OS Interface Configuration Guide
auto-generated
bytes bytes [bytes...(up to 64 max)]
string identifier
auto-generated | string identifier | bytes byte1 [byte2...(up to 64 bytes)]}
• Nodename — The first section is the name of the node.
• iomnum — The second section contains the IOM slot number.
• mdanum — The third section contains the MDA slot number.
• portnum — The fourth section contains the port number.
• dwdmchan — The fifth section contains the DWDM channel number (see Table 29, DWDM
Channel Numbers, on page 280).
bytes, the remaining bytes will be set to 0.
user. If the user provides less than 64 bytes, the remaining bytes will be set to 0. A 1 byte
sequence of 0xFF will set the default strings.
Values 0 — FF, in hexidecimal byte notation
Interface Configuration
Page 291