Alcatel-Lucent 7750 SR OS Interface Configuration Manual page 381

Default
none
Parameters sts3 — Configures STS3/STM1 payload as clear channel.
tu3 — Configures STS3/STM1 payload as Tributary Unit Group 3 (TUG3).
ds3 — Configures the port or channel as DS-3 STS1/VC3 payload as DS-3.
e3 — Configures the port or channel as E-3 STS1/VC3 payload as E-3.
vt2 — Configures the path STS1 payload as vt2 as a virtual tributary group. Only allowed on STS-1
vt15 — Configures the path as a virtual tributary group. Only allowed on STS-1 nodes. (SONET VT
ds1 — Configures the port or channel as DS1.vt15 or vt2 payload as DS-1
e1 — Configures VT2 payload as E-1.
report-alarm
Syntax [no] report-alarms [pais] [plop] [prdi] [pplm] [prei] [puneq] [plcd]
Context config>port>sonet-sdh>path
Description This command enables logging of SONET (SDH) path alarms for a SONET-SDH port. Only path
alarms can be configured in the channel context.
The no form of this command disables logging of the specified alarms.
Parameters
pais — Reports path alarm indication signal errors. When configured, pais alarms are raised and
cleared.
plop — Reports path loss of pointer (per tributary) errors. When configured, plop traps are raised but
not cleared.
prdi — Reports path remote defect indication errors. When configured, prdi alarms are raised and
cleared.
pplm — Reports a path payload mismatch, as a result the channel will be operationally downed.
When configured, pplm traps are raised but not cleared.
prei — Reports a path error condition raised by the remote as a result of b3 errors received from this
node. When configured, prei traps are raised but not cleared.
puneq — Reports path unequipped errors. Reports path unequipped signal errors.
7750 SR OS Interface Configuration Guide
nodes. (SONET VT container)
container)
Default
pais alarms are not issued
Default
plop traps are issued
Default
prdi alarms are not issued
Default
pplm traps are issued
Default
prei traps are not issued
Default puneq traps are issued
Interface Configuration
Page 381