Service Management Tasks; Modifying Or Deleting An Mda, Mcm, Or Cma - Alcatel-Lucent 7750 SR OS Interface Configuration Manual

7750 sr series

Hide thumbs Also See for 7750 SR OS:

Table of Contents

Service Management Tasks

This section discusses basic procedures of the following service management tasks:

To change an MDA or CMA type already provisioned for a specific slot/card, first you must shut

down the slot/MDA/port configuration and then delete the MDA, CMA, and/or the MCM from the

configuration.

Note: To modify or delete CMAs, use the MDA command structure.

Use the following CLI syntax to modify an MDA:

CLI Syntax: config> port port-id

CLI Syntax: config> card slot-number

Note: It is not required to shutdown and remove an MCM to remove or modify an MDA. Use the

following sequence if changing the MCM type or slot configuration.

CLI Syntax: config> card slot-number

Modifying or Deleting an MDA, MCM, or CMA on page 220

Modifying a Card Type on page 221

Deleting a Card on page 222

Deleting Port Parameters on page 222

[no] mda mda-number

[no] mda-type mda-type

[no] hi-bw-mcast-src [alarm] [group group-id]

[no] mcm mcm-number

no mcm-type mcm-type

7750 SR OS Interface Configuration Guide