Alcatel-Lucent 7750 SR OS Interface Configuration Manual page 510

Show Commands
Page 510
Label
Speed
Link-level
MTU
Admin State
Oper State
Duplex
Hold time up
Hold time down
Physical Link
IfIndex
Last State chg
Last State
Change
Configured Mode
Dot1Q Ethertype
QinQ Ethertype
Description (Continued)
The speed of the interface.
Ethernet — The port is configured as Ethernet.
SONET — The port is configured as SONET-SDH.
The size of the largest packet which can be sent/received on the Ether-
net physical interface, specified in octets.
Up — The port is administratively up.
Down — The port is administratively down.
Up — The port is operationally up.
Down — The port is operationally down.
Additionally, the lag-id of the LAG it belongs to in addition to the
status of the LAG member (active or standby) is specified.
Full — The link is set to full duplex mode.
Half — The link is set to half duplex mode.
The link up dampening time in seconds. The port link dampening timer
value which reduces the number of link transitions reported to upper
layer protocols.
The link down dampening time in seconds. The down timer controls
the dampening timer for link down transitions.
Yes — A physical link is present.
— A physical link is not present.
No
Displays the interface's index number which reflects its initialization
sequence.
Displays the system time moment that the peer is up.
Displays the system time moment that the MC-LAG group is up.
network — The port is configured for transport network use.
access — The port is configured for service access.
Indicates the Ethertype expected when the port's encapsulation type is
Dot1Q.
Indicates the Ethertype expected when the port's encapsulation type is
QinQ.
7750 SR OS Interface Configuration Guide