Lldp System Commands - Alcatel-Lucent 7450 Basic System Configuration Manual

src-mac
Syntax src-mac ieee-address
no src-mac
Context config>redundancy>mc>peer>mcr>node>cv
Description
This command specifies the source MAC address used for the Ring-Node Connectivity Verification
of this ring node.
A value of all zeros (000000000000 H (0:0:0:0:0:0)) specifies that the MAC address of the system
management processor (CPM) is used.
Default no src-mac
Parameters
ieee-address — Specifies the source MAC address.
vlan
Syntax [no] vlan
no vlan
Context config>redundancy>mc>peer>mcr>node>cv
Description
This command specifies the VLAN tag of the SAP used for the ring-node connectivity verification of
this ring node. It is only meaningful if the value of service ID is not zero. A zero value means that no
VLAN tag is configured.
Default
no vlan
Parameters vlan — Specifies the set of VLAN IDs associated with the SAPs that are to be controlled by the

LLDP System Commands

lldp
Syntax lldp
Context config>system
Description
This command enables the context to configure system-wide Link Layer Discovery Protocol
parameters.
Basic System Configuration Guide
slave peer.
Values
0 to 4094
System Management
449