Alcatel-Lucent 7450 Basic System Configuration Manual page 361

rising-threshold threshold — Specifies a threshold for the sampled statistic. When the current
falling-event rmon-event-id — The identifier of the rmon>event that specifies the action to be
falling-threshold threshold — Specifies a threshold for the sampled statistic. When the current
owner owner — The owner identifies the creator of this alarm. It defaults to "TiMOS CLI". This
Configuration example
alarm 3 variable-oid ifInOctets.184582144 interval 20 sample-type delta
Basic System Configuration Guide
If a rising-event rmon-event-id is configured, the CLI requires a rising-threshold to also be
configured.
Default 0
Values
0 to 65535
sampled value is greater than or equal to this threshold, and the value at the last sampling
interval was less than this threshold, a single threshold crossing event will be generated. A
single threshold crossing event will also be generated if the first sample taken is greater than
or equal to this threshold and the associated startup-alarm is equal to rising or either.
After a rising threshold crossing event is generated, another such event will not be generated
until the sampled value falls below this threshold and reaches less than or equal the falling-
threshold value.
Default
0
Values -2147483648 to 2147483647
taken when a falling threshold crossing event occurs. If there is no corresponding event
configured for the specified rmon-event-id, then no association exists and no action is taken.
If the falling-event has a value of zero (0), no associated event exists.
If a falling-event is configured, the CLI requires a falling-threshold to also be configured.
Default 0
Values
0 to 65535
sampled value is less than or equal to this threshold, and the value at the last sampling interval
was greater than this threshold, a single threshold crossing event will be generated. A single
threshold crossing event will also be generated if the first sample taken is less than or equal
to this threshold and the associated startup-alarm is equal to falling or either.
After a falling threshold crossing event is generated, another such event will not be generated
until the sampled value rises above this threshold and reaches greater than or equal the rising-
threshold value.
Default
0
Values -2147483648 to 2147483647
parameter is defined primarily to allow entries that have been created in the RMON-MIB
alarmTable by remote SNMP managers to be saved and reloaded in a CLI configuration file.
The owner will not normally be configured by CLI users and can be a maximum of 80
characters long.
Default
TiMOS CLI
System Management
361