Ptp Ordinary Slave Clock For Frequency - Alcatel-Lucent 7450 Basic System Configuration Manual

Message Type
(Duration)
State and statistics data for each PTP peer are available to assist in the detection of failures or
unusual situations.

PTP Ordinary Slave Clock For Frequency

Traditionally, only clock frequency is required to ensure smooth transmission in a
synchronous network. The PTP ordinary clock with slave capability on the router provides
another option to reference a Stratum-1 traceable clock across a packet switched network.
The recovered clock can be referenced by the internal SSU and distributed to all slots and
ports.Figure 20
The PTP slave capability is implemented on the CPM, version 3 or later. The IEEE 1588v2
messages can ingress and egress the router on any line interface.
operation of an ordinary PTP clock in slave mode.
Basic System Configuration Guide
Table 36: Message Rates Ranges and Defaults (Continued)
Rates Requested by the 7X50
Min
300
shows a PTP ordinary slave clock network configuration.
1588v2
Grand
Master
1588v2
Grand
Master
Max
300
Figure 20: Slave Clock
Packet
Network
System Management
Rates Granted by the 7X50
Min
1
PTP Slave
Figure 21
Max
1000
OSSG737
shows the
271