Alcatel-Lucent 7450 Basic System Configuration Manual page 338

System Command Reference
Parameters location-id — Specify the 16 octets that identifies the system loopback location ID as required by
oam
Syntax oam
Context config>system>atm
Description This command configures system-wide ATM parameters and applies only to the 7750 SR.
loopback-period
Syntax loopback-period period
no loopback-period
Context config>system>atm>oam
Description
This command specifies the number of seconds between periodic loopback attempts on an ATM
endpoint that has periodic loopback enabled. This command only applies to the 7750 SR.
Parameters period — Specify the time, in seconds, between periodic loopback attempts.
retry-down
Syntax retry-down retries
no retry-down
Context config>system>atm>oam
Description
Specifies the number of OAM loopback attempts that must fail after the periodic attempt before the
endpoint will transition to AIS-LOC state.
The retry values are configured on a system wide basis and are affective on the next period cycle of
any ATM VC SAP using periodic-loopback, if changed. The timeout for receiving a loopback
response from the remote peer and declaring the loopack failed is 1 second and is not configurable.
This command only applies to the 7750 SR.
338
the ATM OAM Loopback capability. This textual convention is defined in ITU-T standard
I.610.
Invalid values include a location ID where the first octet is: 00, FF, 6A
Acceptable location-ids include values where the first octet is: 01, 03
Other values are not accepted.
Values 01:00:00:00:00:00:00:00:00:00:00:00:00:00:00:00
Values
1 to 40
Default 10
Basic System Configuration Guide