Table of Contents
Advertisement
Booting OmniSwitch 6450 Switches
Viewing the Power Supply Status
To check the status of the power supply, use the
-> show power
Slot
PS
Wattage
----+----+---------+------+-----------+----------
1
1
30
Additional Monitoring Commands
CLI Commands Used for Monitoring a Chassis
show cmm
show ni
show module
show module long
show module status
Using LEDs to Visually Monitor the Chassis
The front and rear panel of provides status LEDs that are useful in visually monitoring the status of the
switches. LEDs include:
Ethernet Port LEDs
•
•
System Status LEDs
Combo Port Status LEDs
•
For tables showing LED states operating normally, refer to
OmniSwitch 6450 Hardware Users Guide
show power
Type
Status
Location
AC
UP
Internal
Displays the basic hardware and status information for primary and
secondary management modules (if applicable).
Displays the basic hardware and status information for individual mod-
ules. If the switch is a standalone, information for the stand alone
switch displays.
Displays the basic information for individual modules. If the switch is a
standalone, information for the stand-alone switch displays.
Displays the detailed information for individual modules. If the switch
is a standalone, information for the standalone switch displays.
Displays the basic status information for individual modules. If the
switch is a standalone, information for the standalone switch displays.
January 2015
command. For example:
"OmniSwitch 6450 LED Status" on page
Monitoring the Chassis
2-32.
page 4-5
Advertisement
Table of Contents
