Alcatel-Lucent 7450 Basic System Configuration Manual page 221

li-separate
Syntax [no] li-separate
Context bof
Description
This command enables separate access to lawful intercept (LI) information.
speed
Syntax speed speed
Context bof
Description
This command configures the speed for the CPM management Ethernet port when autonegotiation is
disabled in the running configuration and the Boot Option File (BOF).
If the port is configured to autonegotiate this parameter is ignored.
Default
speed 100 — 100 M/bps operation.
Parameters
10 — Sets the link to 10 M/bps speed.
100 — Sets the link to 100 M/bps speed.
static-route
Syntax [no] static-route ip-prefix/ip-prefix-length next-hop ip-address
Context bof
Description This command creates a static route entry for the CPM management Ethernet port in the running
configuration and the Boot Option File (BOF).
This command allows manual configuration of static routing table entries. These static routes are only
used by traffic generated by the CPM Ethernet port. To reduce configuration, manual address
aggregation should be applied where possible.
A static default (0.0.0.0/0 or ::/0) route cannot be configured on the CPM Ethernet port. A maximum
of 10 static routes can be configured on the CPM port.
The no form of the command deletes the static route.
Default
No default routes are configured.
Parameters ip-prefix/ip-prefix-length — The destination address of the static route in dotted decimal notation.
Basic System Configuration Guide
Ipv6 is applicable to the 7750 SR and 7950 XRS only.
Values
Boot Options
221