Alcatel-Lucent 7450 Basic System Configuration Manual page 411

hold — Administratively hold a rebooted standby SF/CPM from coming back online. Both the
now — Forces a reboot of the router immediately without an interactive confirmation.
save
Syntax save [file-url] [detail] [index]
Context admin
Description
This command saves the running configuration to a configuration file. For example:
A:ALA-1>admin# save ftp://test:test@192.168.x.xx/./100.cfg
Saving configuration .........Completed.
An admin save operation initiated by a user is aborted if another user initiates another admin save
from another session.
By default, the running configuration is saved to the primary configuration file.
Basic System Configuration Guide
Any CPMs, XCMs, or IOMs that are installed in the chassis will be upgraded automatically.
For example, if a card is inserted with down revision firmware as a result of a card hot swap
with the latest OS version running, the firmware on the card will be automatically upgraded
before the card is brought online.
If the card firmware is upgraded automatically, a chassis cardUpgraded (event 2032) log
event is generated. The corresponding SNMP trap for this log event is
tmnxEqCardFirmwareUpgraded.
During any firmware upgrade, automatic or manual, it is imperative that during the upgrade
procedure:
• Power must NOT be switched off or interrupted.
• The system must NOT be reset.
• No cards are inserted or removed.
Any of the above conditions may render cards inoperable requiring a return of the card for
resolution.
The time required to upgrade the firmware on the cards in the chassis depends on the number
of cards to be upgraded. The progress of a firmware upgrade can be monitored at the console.
control processor (CPM) and the switch fabric (SFM) of the standby SF/CPM are held out of
service. This may be useful for troubleshooting purposes (e.g. standby SF/CPM is suspected
of causing some system problems). The SF/CPM should not be left offline as the system does
not have control or switch fabric redundancy while one SF/CPM is offline. The SF/CPM must
be rebooted again (without the 'hold' keyword) to return it to service. This parameter applies
only to the SF/CPM3 and SF/CPM4 on the 7450 ESS and 7750 SR platforms. Note that on
platforms such as the 7750 SR-12e and 7950 XRS, and on the 7450/7750 SFM5/CPM5, the
SFMs are modeled as separate entities and can be administratively disabled by using the
configure sfm x shutdown command.
System Management
411