Alcatel-Lucent 7450 Basic System Configuration Manual page 427

log-sync-interval
Syntax log-sync-interval log-interval
no log-sync-interval
Context configure>system>ptp>port
Description
This command configures the message interval used for transmission of multicast Sync messages.
For multicast messages used on PTP Ethernet ports, this configures the message interval used for Sync
messages transmitted by the local node when the port is in Master state.
Default
-6 (64 packets per second) for ieee1588-2008 or
-6 (64 packets per second) for g8265dot1-2010 or
-4 (16 packets per second) for g8275dot1-2014
Parameters
log-interval — The message interval, in log form.
log-sync-interval
Syntax log-sync-interval log-interval
no log-sync-interval
Context configure>system>ptp>peer
Description
This command configures the message interval used for unicast event messages. It defines the message
interval for both Sync and Delay_Resp messages that are requested during unicast negotiation to the
specific peer. This controls the Sync and Delay_Resp message rate sent from remote peers to the local
node. It does not affect the Sync or Delay_Resp packet rate that may be sent from the local node to
remote peers. Remote peers may request a Sync or Delay_Resp packet rate anywhere within the
acceptable grant range.
The log-sync-interval cannot be changed unless the peer is shutdown.
Default -6 (64 packets per second) for 1588-2008 or
-6 (64 packets per second) for g8265dot1-2010 or
-4 (16 packets per second) for g8275dot1-2014
Parameters log-interval — Specifies the sync message interval, in log form.
Basic System Configuration Guide
Values -6..0 This corresponds to a maximum rate of 64 packets per
second, and a minimum rate of 1 packet per second.
Values
[-6..0]
System Management
427