Alcatel-Lucent 7450 Basic System Configuration Manual page 137
Ethernet service switch /service router /extensible routing system
Hide thumbs
Also See for 7450:
- Quality of service manual (912 pages) ,
- Manual (816 pages) ,
- Configuration manual (778 pages)
Table of Contents
Advertisement
Monitor commands are similar to show commands but only statistical information displays. Monitor
commands display the selected statistics according to the configured number of times at the interval
specified.
Parameters
neighbor ip-address — The IP address to display information for entries received from the
interval seconds — Configures the interval for each display in seconds.
repeat repeat — Configures how many times the command is repeated.
absolute — When the absolute keyword is specified, the raw statistics are displayed, without
rate — When the rate keyword is specified, the rate-per-second for each statistic is displayed
router-id — The router ID for an existing IP interface.
virtual-link
Syntax
virtual-link nbr-rtr-id area area-id [interval seconds] [repeat repeat] [absolute | rate]
Context
monitor>router>ospf
monitor>router>ospf3
Description
This command displays statistical OSPF virtual link information at the configured interval until the
configured count is reached.
The first screen displays the current statistics related to the specified neighbor(s). The subsequent
statistical information listed for each interval is displayed as a delta to the previous display.
When the keyword rate is specified, the rate-per-second for each statistic is displayed instead of the
delta.
Monitor commands are similar to show commands but only statistical information displays. Monitor
commands display the selected statistics according to the configured number of times at the interval
specified.
Parameters
nbr-rtr-id — The IP address to uniquely identify a neighboring router in the autonomous system.
area area-id — The OSPF area ID, expressed in dotted decimal notation or as a 32-bit decimal
Basic System Configuration Guide
specified OSPF neighbor. Up to 5 IP addresses can be specified.
Default
5 seconds
Values
3 to 60
Default
10
Values
1 to 999
processing. No calculations are performed on the delta or rate statistics.
instead of the delta.
integer.
CLI Usage
137
Advertisement
Table of Contents
