Alcatel-Lucent 7450 Basic System Configuration Manual page 483

53
--------------------------------------------------------------------------------
No. of Rollback Files: 10
================================================================================
ptp
Syntax ptp [standby]
ptp peers [router router-instance | service-name service-name] [detail]
ptp port
ptp port port-id [detail]
ptp statistics
ptp unicast [router router-instance | service-name service-name]
Context show>system
Description
These commands display Precision Time Protocol (PTP) configuration and state information and
apply to the 7450 ESS and 7750 SR. This information can be displayed for the entire node or on a per
router instance basis.
Parameters
standby — Displays information for PTP on the standby control module.
unicast — Displays information related to the unicast sessions.
statistics — Displays the message and error statistics for the node.
peers — Displays summary information for the PTP peers.
peer — Displays information for a single PTP peer.
router router-instance — Qualifier to show only the information for a specific router instance.
detail — Provides additional information on the specified area.
router-instance — router-name | service-id
Output
The following table describes PTP output fields.
Basic System Configuration Guide
.rb.53 2010/10/14 22:10:10
Values
router-name - Base
Values service-id
Table 51: System PTP Field Descriptions
Label Description
Pending When the SR/ESS has initiated a request to a peer but has not yet received a
response.
Granted When the SR/ESS has initiated a request to a peer and it was granted OR a peer
has made a request of the SR/ESS and it was granted.
Denied When the SR/ESS has initiated a request to a peer but it was rejected.
Canceled When a cancel message has been received from or transmitted toward a peer.
9.0.R4
- [1 to 2147483647]
System Management
admin
483