Alcatel-Lucent 7450 Basic System Configuration Manual page 72

Basic CLI Command Reference
group group-ip-address — Specify the multicast address or DNS name of the group that resolves
destination dst-p-address — Specify either the IP address or the DNS name of the unicast
hop hop — Specify the maximum number of hops that will be traced from the receiver back
router-instance — Specify the router name or service ID.
wait-time wait-time — Specify the number of seconds to wait for the response.
password
Syntax password
Context <root>
Description
This command changes a user CLI login password.
When a user logs in after the administrator forces a new-password-at-login, or the password has
expired (aging), then this command is automatically invoked.
When invoked, the user is prompted to enter the old password, the new password, and then the new
password again to verify the correct input.
If a user fails to create a new password after the administrator forces a new-password-at-login or after
the password has expired, the user is not allowed access to the CLI.
72
to the multicast group address that will be used. If the group is not specified, address 224.2.0.1
(the MBone audio) will be used. This will suffice if packet loss statistics for a particular
multicast group are not needed.
destination. If this parameter is omitted the IP address of the system where the command is
entered will be used. The receiver parameter can also be used to specify a local interface
address as the destination address for sending the trace query. The response will also be
returned to the address specified as the receiver.
toward the source.
Values
1 to 255
Default 32 hops (infinity for the DVMRP routing protocol).
Values
router-name:
service-id:
Default
Base
Values
1 to 60
Base, management
1 to 2147483647
Basic System Configuration Guide