Oil Pressure Switch Removal And Installation; Oil Pressure Switch Inspection; Oil Jet / Oil Gallery Jet Removal And Installation - Suzuki GSX-R750 Service Manual

Oil Pressure Switch Removal and Installation

Refer to "Electrical Components Location in Section 0A
(Page 0A-8)".
Removal
1) Turn the ignition switch OFF.
2) Remove the right under cowling. Refer to "Exterior
Parts Removal and Installation in Section 9D
(Page 9D-11)".
3) Drain engine oil. Refer to "Engine Oil and Filter
Replacement in Section 0B (Page 0B-10)".
4) Disconnect the oil pressure switch lead wire (1).
5) Remove the oil pressure switch (2).
1
Installation
1) Install the oil pressure switch (1) and tighten it to the
specified torque.
Tightening torque
Oil pressure switch (a): 14 N·m (1.4 kgf-m, 10.0
lb-ft)
1
B838H21506007
2
I837H1150017-01
(a)
I837H1150018-01
Engine Lubrication System:
2) Connect the oil pressure switch lead wire securely.
Refer to "Wiring Harness Routing Diagram in
Section 9A (Page 9A-3)".
Tightening torque
Oil pressure switch lead wire bolt (b): 1.5 N·m (
0.15 kgf-m, 1.1 lb-ft)
3) Pour engine oil. Refer to "Engine Oil and Filter
Replacement in Section 0B (Page 0B-10)".
4) Install the right under cowling. Refer to "Exterior
Parts Removal and Installation in Section 9D
(Page 9D-11)".

Oil Pressure Switch Inspection

Refer to "Oil Pressure Indicator Inspection in Section 9C
(Page 9C-6)".

Oil Jet / Oil Gallery Jet Removal and Installation

Oil Jet (For Pistons)
Removal
1) Remove the engine assembly. Refer to "Engine
Assembly Removal in Section 1D (Page 1D-19)".
2) Remove the Crankshaft assembly. Refer to "Engine
Bottom Side Disassembly in Section 1D (Page 1D-
47)".
3) Remove the piston cooling oil jets (1) from the upper
crankcase.
(b)
I837H1150019-01
B838H21506008
B838H21506009
1
I837H1150020-02
1E-9