Connecting to the switch
Creating a VLAN using ACLI
Use this procedure to create port-based or IPv6 protocol-based VLANs.
Important:
This procedure fails if the VLAN already exists.
Procedure
1. Enter Global Configuration mode:
enable
configure terminal
2. At the command prompt, enter the following command:
vlan create {<1–4094> | <vid_list>} [name <WORD>] [ type { port |
protocol-ipv6Ether2 | voice-vlan}] | [voice-vlan] [msti <1–7> |
cist]
Example
vlan create 2-10,80 type port
vlan create 15 type voice-vlan
Variable definitions
The following table describes the parameters for the vlan create command.
Variable
<1–4094> | <vid_list>
name <WORD>
type
msti <1–7> | cist
September 2016
Value
Enter the ID of the VLAN you want to create or enter
as a list or range of VLAN IDs to create multiple
VLANs simultaneously. A VLAN ID can range from 1
to 4094..
Enter the new name you want for the VLAN.
Enter the type of VLAN. Values include:
• port — port-based VLAN
• protocol-ipv6Ether2 — IPv6 protocol-based VLAN
• voice-vlan — voice VLAN
This parameter is available only in MSTP mode. It
associates the VLAN with either an MSTI instance or
the CIST.
Quick Start Configuration
Comments on this document? infodev@avaya.com
36