Table of Contents
Advertisement
Connecting the Core module to a LAN
Cabling Common Equipment in a Multi Group system
Connect each Core/Net module to a local area network (LAN). This
connection provides a communication channel for LAN based systems
management tools such as Element Manager. This connection also supplies
additional redundancy capabilities. See Figure 94 on
Note 1: If a LAN is not available, connect the second NTRC17BA
crossover Ethernet cable (included in the basic package) between the J31
ports in Core/Net 0 and Core/Net 1.
Note 2: The Core/Net I/O panel cables must be installed as described on
"Installing the CP PIV to I/O panel cables" on
Ethernet connections can be completed.
Procedure 33
Connecting the Core module to a LAN
1
Label both sides of two customer supplied Ethernet cables.
2
Connect a CAT5 Ethernet cable from J31 (top) on the Core/Net 0 I/O
panel to the LAN switch.
3
Connect a second CAT5 Ethernet cable from J31 (top) on the Core/Net 1
I/O panel to the LAN switch.
Large System Installation and Commissioning
Page 227 of 436
page
228.
page 224
before the
Advertisement
Table of Contents
