Table of Contents
Advertisement
Disconnecting cables from the Core/Net module backplane
Cabling Common Equipment in a Multi Group system
Procedure 30
Cabling the Core/Net module backplane
1
Orient the cable connector so the strain relief paddle is to the right.
2
Partially insert the cable connector so its guides mate to the
corresponding backplane connector.
3
Apply a small amount of pressure to push the cable connector straight into
the backplane connector. You will feel a click when the connector seats.
To disconnect cables from the Core/Net module backplane, you must use the
P0741489 Extraction Tool provided, located in the rear of the module (behind
the I/O safety panel).
CAUTION — Service Interruption
Damage to Equipment
Use the P0741489 Extraction Tool to disconnect
cables from the backplane shrouds in NT4N41 Core/
Network modules.
Follow the procedure below to avoid bending or
breaking pins when removing cable connectors from
the backplane shrouds.
Do not insert the extraction tool unless the cable
connector is locked into the shroud.
Do not force the extraction tool deeper than the
detent on the cable connector.
Do not improvise with common hand tools.
End of Procedure
Large System Installation and Commissioning
Page 217 of 436
Advertisement
Table of Contents
