Table of Contents
Advertisement
Figure 148
Selected J2-J5 plate on back panel of UEM
8
Establish an ELAN port on the back panel of the UEM.
a.
Insert the end of one of the RJ-45 CAT5 Ethernet patch cables
(supplied) into the ELAN network interface (ELAN port) on the Server
faceplate.
b.
Route the Ethernet patch cable through the hole you made in the
back panel of the UEM.
c.
Plug the other end of the Ethernet patch cable into one of the
Ethernet port couplers mounted in the Ethernet port adapter plate.
d.
Label the Ethernet port coupler as ELAN.
See Figure 149 and Figure 150.
lnstalling a Signaling Server
Large System Installation and Commissioning
Page 401 of 436
Advertisement
Table of Contents
