Table of Contents
Advertisement
Page 424 of 436
NN43021-310
Standard 06.01
lnstalling a Signaling Server
Figure 163
CP PM BIOS automatic upgrade
7
Verify that the BIOS upgrade is finished. Press Enter to reboot.
8
During the reboot memory check, press Ctrl c to access the CP PM BIOS
setup menu.
Note: If you miss the timing to press Ctrl c you must reboot the system
and try again. The Linux Platform Base installation software will display a
warning if you do not reset the CP PM BIOS to factory defaults.
9
Figure 164 appears. Select Reset CMOS to factory defaults from the
menu.
March 2013
Advertisement
Table of Contents
