Table of Contents
Advertisement
3
Disconnect power connections to the top cap:
a.
At the top of the rear of the module, disconnect the orange power
connector from the module power harness (see Figure 120 on
page
359). Press the four tabs (two on each side) and let the
connector fall loose into the module below.
Figure 120
Orange power connector removal tab locations
b.
Disconnect the system monitor cable at connector J2 on the
backplane.
4
Remove the top cap and perforated panel:
•
For countries other than the UK, pull forward on the clips underneath
the front edge of each air exhaust grill on the top cap. Lift up and
remove the grill as illustrated in Figure 121 on
Figure 121
Air exhaust grill removal
Air exhaust grill
•
In the UK, the front and rear air exhaust grills are secured by Southco
fasteners located underneath the front edge of the grill. Use a #1
Adding a module to a column
Push here
Orange connector
Push here
Top cap
Air exhaust grill
Module
Large System Installation and Commissioning
Page 359 of 436
553-5888
page
359).
Clips
553-5886
Advertisement
Table of Contents
