Table of Contents
Advertisement
Page 186 of 436
NN43021-310
Standard 06.01
Connecting a system terminal or modem
3
At the local end, configure the modem.
Follow the manufacturer's instructions to set the modem for 9600 baud,
auto answer, dumb mode, command recognition OFF, command echo
OFF.
4
At the local end, connect an NT8D95 cable to the SDI port on the I/O
panel in the rear of the module and to the modem.
5
At the local end, connect the cable from the modem to an RJ11 telephone
jack. If a cable is required, connect an NT8D46 cable to the modem and
to the RJ11 jack.
6
To communicate with a COM2 port, switch the cable from the modem to
the port as needed.
•
For debugging or monitoring, connect the cable to the active CPU at
J21 on the I/O panel in the rear of the cPCI Core/Network Module.
•
For patch downloading, connect the cable to the inactive CPU at J21
on the I/O panel in the rear of the cPCI Core/Network Module.
March 2013
End of Procedure
Advertisement
Table of Contents
