Table of Contents
Advertisement
Figure 23
Positioning spacer gaskets
Rear
f.
Attach a spacer to one side of each module, except the end column
(see Figures 24 and 25).
— Position a spacer against the module.
— Insert one standoff between the spacer and module.
— Insert the one screw and tighten.
— Repeat the process for the remaining standoff and screws.
CAUTION — Service Interruption
Damage to Equipment
Do not try to adjust the horizontal position of a
column by tightening the spacer screws. Tightening
the screws with the columns too far apart will warp
the spacer.
g.
One at a time, push columns together, level, align, and attach the
other side of the spacers.
Positioning and leveling equipment
Gasket placement
Large System Installation and Commissioning
Page 77 of 436
Front
553-5641
Advertisement
Table of Contents
